EasyManua.ls Logo

NXP Semiconductors K22F series - Page 344

NXP Semiconductors K22F series
1407 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LVD (without POR) — 0x00
VLLS mode wakeup — 0x00
Other reset — a bit is set if its corresponding reset source
caused the reset
Address: 4007_F000h base + 1h offset = 4007_F001h
Bit 7 6 5 4 3 2 1 0
Read 0 0 SACKERR EZPT MDM_AP SW LOCKUP JTAG
Write
Reset
0 0 0 0 0 0 0 0
RCM_SRS1 field descriptions
Field Description
7
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
6
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
5
SACKERR
Stop Mode Acknowledge Error Reset
Indicates that after an attempt to enter Stop mode, a reset has been caused by a failure of one or more
peripherals to acknowledge within approximately one second to enter stop mode.
0 Reset not caused by peripheral failure to acknowledge attempt to enter stop mode
1 Reset caused by peripheral failure to acknowledge attempt to enter stop mode
4
EZPT
EzPort Reset
Indicates a reset has been caused by EzPort receiving the RESET command while the device is in EzPort
mode.
0 Reset not caused by EzPort receiving the RESET command while the device is in EzPort mode
1 Reset caused by EzPort receiving the RESET command while the device is in EzPort mode
3
MDM_AP
MDM-AP System Reset Request
Indicates a reset has been caused by the host debugger system setting of the System Reset Request bit
in the MDM-AP Control Register.
0 Reset not caused by host debugger system setting of the System Reset Request bit
1 Reset caused by host debugger system setting of the System Reset Request bit
2
SW
Software
Indicates a reset has been caused by software setting of SYSRESETREQ bit in Application Interrupt and
Reset Control Register in the ARM core.
0 Reset not caused by software setting of SYSRESETREQ bit
1 Reset caused by software setting of SYSRESETREQ bit
1
LOCKUP
Core Lockup
Indicates a reset has been caused by the ARM core indication of a LOCKUP event.
0 Reset not caused by core LOCKUP event
1 Reset caused by core LOCKUP event
Table continues on the next page...
Reset memory map and register descriptions
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
344 NXP Semiconductors

Table of Contents

Related product manuals