EasyManua.ls Logo

NXP Semiconductors K22F series - Page 915

NXP Semiconductors K22F series
1407 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Bit
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
0
SWSYNC
TRIG2
TRIG1
TRIG0
SYNCHOM
REINIT
CNTMAX
CNTMIN
W
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
FTMx_SYNC field descriptions
Field Description
31–8
Reserved
This field is reserved.
This read-only field is reserved and always has the value 0.
7
SWSYNC
PWM Synchronization Software Trigger
Selects the software trigger as the PWM synchronization trigger. The software trigger happens when a 1 is
written to SWSYNC bit.
0 Software trigger is not selected.
1 Software trigger is selected.
6
TRIG2
PWM Synchronization Hardware Trigger 2
Enables hardware trigger 2 to the PWM synchronization. Hardware trigger 2 happens when a rising edge
is detected at the trigger 2 input signal.
0 Trigger is disabled.
1 Trigger is enabled.
5
TRIG1
PWM Synchronization Hardware Trigger 1
Enables hardware trigger 1 to the PWM synchronization. Hardware trigger 1 happens when a rising edge
is detected at the trigger 1 input signal.
0 Trigger is disabled.
1 Trigger is enabled.
4
TRIG0
PWM Synchronization Hardware Trigger 0
Enables hardware trigger 0 to the PWM synchronization. Hardware trigger 0 occurs when a rising edge is
detected at the trigger 0 input signal.
0 Trigger is disabled.
1 Trigger is enabled.
3
SYNCHOM
Output Mask Synchronization
Selects when the OUTMASK register is updated with the value of its buffer.
0 OUTMASK register is updated with the value of its buffer in all rising edges of the system clock.
1 OUTMASK register is updated with the value of its buffer only by the PWM synchronization.
2
REINIT
FTM Counter Reinitialization By Synchronization (FTM counter synchronization)
Determines if the FTM counter is reinitialized when the selected trigger for the synchronization is detected.
The REINIT bit configures the synchronization when SYNCMODE is zero.
0 FTM counter continues to count normally.
1 FTM counter is updated with its initial value when the selected trigger is detected.
Table continues on the next page...
Chapter 39 FlexTimer Module (FTM)
K22F Sub-Family Reference Manual, Rev. 4, 08/2016
NXP Semiconductors 915

Table of Contents

Related product manuals