UM10360 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2013. All rights reserved.
User manual Rev. 3 — 20 December 2013 802 of 841
35.1 Abbreviations
UM10360
Chapter 35: Supplementary information
Rev. 3 — 20 December 2013 User manual
Table 691. Abbreviations
Acronym Description
ADC Analog-to-Digital Converter
AHB Advanced High-performance Bus
AMBA Advanced Microcontroller Bus Architecture
APB Advanced Peripheral Bus
BOD BrownOut Detection
CAN Controller Area Network
DAC Digital-to-Analog Converter
DCC Debug Communication Channel
DMA Direct Memory Access
DSP Digital Signal Processing
EOP End Of Packet
ETM Embedded Trace Macrocell
GPIO General Purpose Input/Output
IrDA Infrared Data Association
JTAG Joint Test Action Group
MIIM Media Independent Interface Management
PHY Physical Layer
PLL Phase-Locked Loop
PWM Pulse Width Modulator
RMII Reduced Media Independent Interface
SE0 Single Ended Zero
SPI Serial Peripheral Interface
SSI Serial Synchronous Interface
SSP Synchronous Serial Port
TTL Transistor-Transistor Logic
UART Universal Asynchronous Receiver/Transmitter
USB Universal Serial Bus
To Next Page
Loading...
Need help?
General
