DocID024597 Rev 3 1039/1693
RM0351 Low-power timer (LPTIM)
1045
Bits 15:13 TRIGSEL: Trigger selector
The TRIGSEL bits select the trigger source that will serve as a trigger event for the LPTIM among the
below 8 available sources:
000: ext_trig0
001: ext_trig1
010: ext_trig2
011: ext_trig3
100: ext_trig4
101: ext_trig5
110: ext_trig6
111: ext_trig7
Bit 12 Reserved, must be kept at reset value.
Bits 11:9 PRESC: Clock prescaler
The PRESC bits configure the prescaler division factor. It can be one among the following division
factors:
000: /1
001: /2
010: /4
011: /8
100: /16
101: /32
110: /64
111: /128
Bit 8 Reserved, must be kept at reset value.
Bits 7:6 TRGFLT: Configurable digital filter for trigger
The TRGFLT value sets the number of consecutive equal samples that should be detected when a
level change occurs on an internal trigger before it is considered as a valid level transition. An internal
clock source must be present to use this feature
00: any trigger active level change is considered as a valid trigger
01: trigger active level change must be stable for at least 2 clock periods before it is considered as
valid trigger.
10: trigger active level change must be stable for at least 4 clock periods before it is considered as
valid trigger.
11: trigger active level change must be stable for at least 8 clock periods before it is considered as
valid trigger.
Bit 5 Reserved, must be kept at reset value.
To Next Page
Loading...
Need help?
General
