6. Set the properties for Internet Fax data format other than the mode selection.
If you change the mode to “Simple Mode”, you cannot set machine properties.
7. Click [OK] at the upper or lower left of the screen.
To cancel the setting, click [Cancel] at the upper or lower left of the screen.
The Address Book is displayed.
8. Close the Web browser.
To add new receiver
Use Web Image Monitor to add a new destination to the Address Book.
1. Start a Web browser.
2. Enter “http://(IPv4 address, IPv6 address or host name of this machine)/” in the address
bar.
The top page of Web Image Monitor is displayed.
3. Click [Login], and then enter the Administrator's name and password.
4. Click [Address Book] in the left pane.
The Address Book is displayed.
5. Click [Add User].
The [Add User] page appears.
6. Enter the registration number, name, and e-mail address, then set the necessary
properties.
You can set the Internet Fax data format after entering the e-mail address.
7. Click [Full Mode] under [Internet Fax Data Format], and set the properties according to
the receiver's properties.
If you change the mode to “Simple Mode”, you cannot set machine properties.
8. Click [OK] at the upper or lower left of the screen.
To cancel the setting, click [Cancel] at the upper or lower left of the screen.
The Address Book is displayed.
9. Close the Web browser.
Viewing Fax Information Using a Web Browser
345
To Next Page
