• Specify the IPv6 address to destination and gateway.
•
If the prefix of the address is between 1 and 127, the network is selected. If the prefix of the
address is 128, the host is selected.
• You cannot register a record that has the same destination and prefix as a registered record.
• You cannot register a record that uses "0000:0000:0000:0000:0000:0000:0000:0000"
as its destination.
Deleting a specified IPv6 destination from routing table
msh> route delete6 "destination" "prefixlen"
• Specify the IPv6 address to destination and gateway.
Display information about a specified IPv6 route information
msh> route get6 "destination"
• Specify the IPv6 address to destination and gateway.
Enabling/disabling a specified IPv6 destination
msh> route active6 "destination" "prefixlen[1-128]" {on|off}
Route initialization
msh> route flush
• The maximum number of IPv4 routing tables is 16.
•
The maximum number of IPv6 routing tables is 2.
• Set a gateway address when communicating with devices on an external network.
• The same gateway address is shared by all interfaces.
• "Prefixlen" is a number between 1 and 128.
set
Use the "set" command to set the protocol information display "up" or "down".
View settings
The following command displays the protocol information (up/down).
msh> set ipv4
msh> set ipv6
msh> set ipsec
msh> set netware
• This command is available only when the NetWare is installed.
msh> set smb
Remote Maintenance Using telnet
173
To Next Page
Loading...
