msh> set rfu {up|down}
msh> set rfu6 {up|down}
msh> set ipp {up|down}
msh> set ipp6 {up|down}
msh> set http {up|down}
msh> set http6 {up|down}
msh> set bonjour {up|down}
msh> set bonjour6 {up|down}
msh> set ssh {up|down}
msh> set ssdp {up|down}
msh> set nbt {up|down}
msh> set sftp {up|down}
msh> set sftp6 {up|down}
msh> set wsdev {up|down}
msh> set wsdev6 {up|down}
• If "wsdev" and "wsdev6" are enabled simultaneously, both appear as "up" on the protocol
information display, but both use IPv4 for WSD (Device), WSD (Printer) and WSD (Scanner).
msh> set wsprn {up|down}
msh> set wsscn {up|down}
msh> set rhpp {up|down}
msh> set rhpp6 {up|down}
msh> set lltd {up|down}
show
Use the "show" command to display the network interface board configuration settings.
View settings
msh> show
• If "-p" is added, you can view settings one by one.
• p.202 "Understanding the Displayed Information"
4. Monitoring and Configuring the Machine
176
To Next Page
Loading...
