View protocol
msh> smb protocol
Displaying higher priority SMB client ports
msh> smb client port
Specifying higher priority SMB client ports
msh> smb client port {139|445}
Displaying SMB client authentication level
msh> smb client auth
Specifying SMB client authentication level
msh> smb client auth {0|1}
snmp
Use the "snmp" command to display and edit the SNMP configuration settings such as the community
name.
View settings
"IPX" is shown only when the NetWare is installed.
msh> snmp
• Default access settings 1 is as follows:
Community name:public
IPv4 address:0.0.0.0
IPv6 address:::
IPX address:00000000:000000000000
Access type:read-only
Effective Protocol:IPv4/IPv6/IPX
• Default access settings 2 is as follows:
Community name:admin
IPv4 address:0.0.0.0
IPv6 address:::
IPX address:00000000:000000000000
Access type:read-write
Effective Protocol:IPv4/IPv6/IPX
• If "-p" is added, you can view settings one by one.
• To display the current community, specify its registration number.
4. Monitoring and Configuring the Machine
178
To Next Page
Loading...
