4. Enter a login user name, and then press [OK].
When you assign the administrator for the first time, enter "supervisor".
5. Enter a login password, and then press [OK].
When the supervisor is making settings for the first time, a password is not required; the supervisor
can simply press [OK] to proceed.
The message, "Authenticating... Please wait." appears.
Logging out as the Supervisor
If administrator authentication has been specified, be sure to log out after completing settings. This
section describes how to log out after completing settings.
1. Press the [Login/Logout] key.
2. Press [Yes].
Changing the Supervisor
This section describes how to change the supervisor's login name and password.
To do this, you must enable the user administrator's privileges through the settings under "Administrator
Authentication Management". For details, see "Specifying Administrator Privileges".
1. Press the [User Tools/Counter] key.
2. Press the [Login/Logout] key.
3. Log in as the supervisor.
You can log in the same way as an administrator.
4. Press [System Settings].
5. Press [Administrator Tools].
6. Press [Program / Change Administrator].
If this item is not visible, press [ Next] to display more settings.
10. Appendix
302
To Next Page
Loading...
