• p.105 "Scan Profile Items and Settings"
•
p.89 "Preparation for Sending Files Using WSD"
• p.104 "Creating a New Scan Profile"
Creating a New Scan Profile
Use the following procedure to create a new profile.
1. On the [Start] menu, click [Control Panel].
Control Panel opens.
2. Click [Hardware and Sound].
You do not have to perform this step depending on the Control Panel settings.
3. Click [Scanners and Cameras].
The [Scanners and Cameras] dialog box appears.
4. Select this machine, and then click [Scan Profiles].
The [Scan Profiles] dialog box appears.
5. Click [Add].
The [Add New Profile] dialog box appears.
6. Configure the necessary settings for the profile.
For details, see “Scan Profile Items and Settings”.
7. Click [Save Profile].
The scan settings are saved as a new profile.
• You can register multiple profiles. If multiple profiles are registered, the profile specified as default
in the [Scan Profiles] dialog box is applied.
•
To specify a scan profile as the default profile, perform one of the following procedures:
• In the [Scan Profiles] dialog box, click the scan profile, and then click [Set as Default].
• After you create a new scan profile, in the [Add New Profile] dialog box, select the [Set this
profile as default] check box.
• p.105 "Scan Profile Items and Settings"
3. Sending Scan Files Using WSD
104
To Next Page
Loading...
