Aficio MP 2352 - Sending by Internet Fax (Internet Fax Destinations)

• To send via IPv6, you must specify, for the receiver's IPv6 address and host name, the manually
configured address for the receiver's fax.
•
For reception when not using SIP server in an IPv6 environment, you must specify this machine's
IPv6 address manually. This is not necessary if you are using SIP server.
• To send by IPv4 when using SIP server in a mixed IPv4/IPv6 environment, enter “v4:” at the
beginning of the IP-Fax destination. Likewise, to send by IPv6 when using SIP server in a mixed
IPv4/IPv6 environment, enter “v6:” at the beginning of the IP-Fax destination.
• “SIP call setup” is performed either by IPv4 or IPv6, depending on the configuration of your
environment.
• If you are using a gatekeeper/SIP server, the operation switch indicator will sometimes flash even
after you press the operation switch to turn it off.
Setting a port number
When using IP address and port number
To send to an IP-Fax destination, depending on the receiver's network configuration, you might
have to specify the IPv4 address and port number of the receiving machine. For example, if the
receiver's IPv4 address is “192.168.1.10” and the port number is “2100”, specify
“192.168.1.10:2100”. Similarly, if the receiver's IPv6 address is “fe80::0123:4567:89ab:cdef”
and the port number is “2200”, specify “[fe80::0123:4567:89ab:cdef]:2200”. Ask your network
administrator for details.
When using host name and port number
When you specify a host name, depending on the receiver's network configuration, you may need
to specify the host name and port number of the receiving machine. For example, if the receiver's
host name is “IPFAX1” and the port number is “2100”, specify “IPFAX1:2100”. Ask the network
administrator for details.
Sending by Internet Fax (Internet Fax Destinations)
This section explains how to specify an Internet Fax destination.
When using Internet Fax transmission, specify the e-mail address (Internet Fax destination) in place of
the fax number.
• You can also enter a computer's e-mail address as the destination. In this case, you can send TIFF
files only.
•
To send an Internet Fax, you must specify the sender.
• The sender must be registered in the Address Book in advance. Register his/her e-mail address and
specify “Use Name as” for [Sender] using “Address Book Management” in “System Settings”. For
Specifying a Destination
95
1