• Depending on your computer's operating system, the [AutoPlay] dialog box may appear. If this
happens, click [Run SETUP.EXE]. If the [User Account Control] dialog box appears, click [Yes] or
[Continue] to allow the auto play program to run.
•
A user code can be set after the printer driver installation. For information about user code, see the
printer driver Help.
• Auto Run may not work with certain operating system settings. In that case, launch "Setup.exe" on
the CD-ROM root directory.
Changing the Port Settings for SmartDeviceMonitor for Client
Follow the procedure below to change the SmartDeviceMonitor for Client settings, such as TCP/IP
timeout, recovery/parallel printing, and printer groups.
Windows XP, Windows Server 2003 / 2003 R2:
1. Open the [Printers and Faxes] window from the [Start] menu.
The [Printers and Faxes] window appears.
2. Click the icon of the machine you want to use. On the [File] menu, click [Properties].
The printer properties appear.
3. Click the [Ports] tab, and then click [Configure Port...].
The [Port Configuration] dialog box appears.
•
User, proxy, and timeout settings can be configured for IPP.
• For information about these settings, see SmartDeviceMonitor for Client Help.
Windows Vista, Windows Server 2008:
1. Open the [Printers] window from [Control Panel] on the [Start] menu.
The [Printers] window appears.
2. Right - click the icon of the machine you want to use, and then click [Properties].
The printer properties appear.
3. Click the [Port] tab, and then click [Configure Port].
The [Port Configuration] dialog box appears.
•
User, proxy, and timeout settings can be configured for IPP.
Using the SmartDeviceMonitor for Client Port
27
To Next Page
Loading...
