• 0: On
•
1: Off
Changing the User Parameters
This section describes how to set parameters.
• Access to some User Parameter Settings may require options, or other settings may need to be
made beforehand.
•
It is recommended that you print and keep a User Parameter list when you program or change a
User Parameter.
• Do not change any bit switches other than those shown on the previous pages.
1. Press [Facsimile Features].
2. Press [Initial Settings].
3. Press [Parameter Setting].
4. Select the switch number you want to change.
5. Select the bit number you want to change.
When the bit number is pressed, the current value switches between 1 and 0.
Repeat from step 5 to change another bit number for the same switch.
6. Press [OK].
To cancel these settings, press [Cancel]. The display returns to that of step 4.
7. Repeat step 4 through step 6 to change the switch settings.
8. After all the settings are finished, press [Exit].
9. Press the [User Tools/Counter] key.
Parameter Settings
399
To Next Page
