If Error Occurs with the Specified Paper Size
and Type
An error message appears on the control panel when there is no tray for the selected paper size or type,
or when paper loaded in the machine has run out. In that case, you can select the tray manually to
continue printing, or cancel a print job.
• The tray cannot be changed if the following functions are set:
•
Staple
• Punch
• Duplex Print to a tray that does not support duplex printing
• Front and Back Cover
• Slip Sheet
• Chaptering
• Chapter Slip Sheets
• If you cancel duplex printing through the error message, printing will continue from the tray that
you select manually.
•
If any of the following functions are set, you can continue printing by canceling the function:
• Staple
• Punch
• Duplex
• If [Auto Continue] is enabled, printing from the manually selected tray will begin after a specified
interval. For details about [Auto Continue], see "System".
• p.153 "System"
Printing from a Selected Tray
Use the following procedure to manually select the tray from which printing will continue.
1. Press the [Printer] key.
2. Select a tray those that appear on the control panel to continue printing manually.
If you want to print after adding paper to the tray, select the tray after loading the correct paper.
2. Printing Documents
94
To Next Page
Loading...
