• While scanning an original
•
The copy display is set as the default screen when the machine is turned on. You can change this
default setting under Function Priority. See “System Settings”, Network and System Settings
Reference
.
System Reset
This section explains System Reset.
After finishing a job, the machine waits a specified length of time and then restores its settings to the
default values specified under Function Priority. This function is called “System Reset”. For the procedure
for specifying default settings under Function Priority, see “System Settings”, Network and System
Settings Reference .
To change the length of time that the machine waits before restoring its settings to their default values,
use the System Auto Reset Timer setting. See “System Settings”, Network and System Settings Reference
.
2. Getting Started
48
To Next Page
Loading...
