Changing the Paper Size
This section describes how to change the paper size.
• When loading paper, take care not to trap or injure your fingers.
• Do not stack paper over the limit mark.
• (mainly Europe and Asia)
The LCT can hold A4 paper only. If you want to print on any of 8
1
/
2
× 11 paper sizes from
LCT, contact your service representative.
• (mainly North America)
The LCT can hold 8
1
/
2
× 11 paper only. If you want to print on any of A4 paper sizes from
LCT, contact your service representative.
• Be sure to select the paper size with User Tools. If you do not, misfeeds might occur. For details
about Tray Paper Size, see “System Settings”, Network and System Settings Reference .
•
Fan the paper before loading.
• Straighten curled or warped paper before loading.
• For details about paper sizes and types, see “Recommended Paper Sizes and Types”.
• p.70 "Recommended Paper Sizes and Types"
Changing the Paper Size in Trays 1 - 4
This section describes how to change the paper size in trays 1 4.
The paper size setting is changed in the same way for each paper tray.
In the following example procedure, the paper size setting for tray 2 is changed.
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
•
Check the paper edges are aligned at the right side.
• When loading small quantities of paper, be careful not to squeeze the side fences in too tightly, as
the paper will not feed properly.
3. Adding Paper
62
To Next Page
Loading...
