1. This machine
Scans originals after receiving a scanning request from a client computer, and then sends the scan files over
the network to the client computer.
2.
Client computers (WSD-compliant)
You can specify scan settings and send scanning requests from client computers using Windows Fax and Scan
or a similar application. Client computers can receive files scanned by this machine.
Preparation for Sending Files Using WSD
To send scanned files using WSD, you must first perform the following:
•
Check the machine is properly connected to the network
• Configure the network settings in [System Settings]
• Enable WSD using Web Image Monitor
• Register the machine to a client computer
Checking the machine is properly connected to the network
Check that this machine is properly connected to the network.
For details about how to connect this machine to a network, see "Connecting to the Interface", Network
and System Settings Reference.
Configuring the network settings in [System Settings]
Configure the network settings in [System Settings] according to your environment and how you will be
using the machine.
The following procedure explains connecting this machine to an IPv4 network using Ethernet cable.
Note that the settings you must configure will vary depending on your operating environment. For details
about network settings and configuration procedures, see "Network Settings Required to Use WSD
Scanner", Network and System Settings Reference.
Before Sending Scan Files Using WSD
89
To Next Page
Loading...
