• An administrator's privileges can only be changed by an administrator with the relevant privileges.
•
Administrator privileges cannot be revoked by any single administrator.
• p.35 "Logging in Using Administrator Authentication"
•
p.36 "Logging out Using Administrator Authentication"
Changing the Administrator's User Name and Password
Using Web Image Monitor, you can log into the machine and change the administrator's user name and
password.
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
3. Click [Login].
4. Enter the login name and password of an administrator, and then click [Login].
When logging in as an administrator, use the login name and password of an administrator set in
the machine. The default login name is "admin" and the password is blank.
5. Click [Configuration], and then click [Program/Change Administrator] under "Device
Settings".
6. Enter the new login user name of the administrator whose name you wish to change.
7. Click [Change] next to "Login Password" under the administrator whose password you
wish to change.
8. Enter the new password in the "New Password" and "Confirm Password" fields, and then
click [OK].
9. Click [OK].
If the login information is changed successfully, an authentication message appears.
10. Click [OK].
The login screen appears.
• The Web browser might be configured to auto complete login dialog boxes by retaining user
names and passwords. This function reduces security. To prevent the browser retaining user names
and passwords, disable the browser's auto complete function.
Enabling Administrator Authentication
37
To Next Page
Loading...
