wiconfig
Use the "wiconfig" command to make settings for IEEE 802.11.
View settings
msh> wiconfig
View IEEE 802.11 information
msh> wiconfig cardinfo
If IEEE 802.11 is disabled or unavailable, information about it will not appear.
Configuration
msh> wiconfig "parameter"
Parameter Value configured
mode {ap|802.11adhoc} You can set the infrastructure mode (ap) or the
802.11 Ad hoc mode (802.11adhoc).
The default is the infrastructure mode.
ssid "ID value" You can specify an SSID in infrastructure
mode. The characters you can enter in the
SSID string are ASCII 0x20-0x7e (32 bytes). If
you do not specify a character string, the
machine will connect to the nearest access
point.
The default SSID is blank.
channel "channel no." In 802.11 ad hoc mode, you can select a
channel.
Be sure to set the same channel for all ports
that will transmit and receive data.
The default is "11".
The channel in use might differ depending on
the country. For details, see "Wireless LAN".
4. Monitoring and Configuring the Machine
186
To Next Page
Loading...
