Parameter Value configured
key "key value" val [1|2|3|4] You can specify the WEP key by entering in
hexadecimal.
With a 64-bit WEP, you can use 10 digit
hexadecimals. With a 128-bit WEP, you can
use 26 digit hexadecimals.
Up to four WEP keys can be registered.
Specify the number to be registered with "val".
When a WEP is specified by key, the WEP
specified by key phrase is overwritten.
To use this function, set the same key number
and WEP key for all ports that transmit data to
each other. Put "0x"on the front of WEP key.
You can omit the numbers with "val". The key
number is set to 1 when making these
omissions. The default is blank.
keyphrase "phrase" val [1|2|3|4] You can specify the WEP key by entering in
ASCII.
With a 64-bit WEP, you can use 5 digit
hexadecimals. With a 128-bit WEP, you can
use 13 digit hexadecimals.
Up to four WEP keys can be registered.
Specify the number to be registered with "val".
When a WEP is specified by key phrase, the
WEP specified by key is overwritten.
To use this function, set the same key number
and WEP key for all ports that transmit data to
each other.
You can omit the numbers with "val". The key
number is set to1 when making these
omissions. The default is blank.
encval [1|2|3|4] You can specify which of the four WEP keys is
used for packet encoding. "1" is set if a number
is not specified.
Remote Maintenance Using telnet
187
To Next Page
Loading...
