Message List
This is a list of messages that appear in the machine's system log. The system log can be viewed using
the "syslog" command.
System Log Information
Use the following command to display the system log information:
•
UNIX: Use the "syslog" parameter and the "rsh", "rcp", "ftp", and "sftp" commands. "rsh" and "rcp"
cannot be used in a Windows environment.
• telnet: Use the "syslog" command.
Message Problem and solutions
Access to NetWare server <file server name>
denied. Either there is no account for this print
server on the NetWare server on password was
incorrect.
Login to the file server failed when the print server
was online. Make sure the print server is
registered in <file server name>. If a password is
specified for the print server, delete the password.
account is unavailable:
same account name be used.
User account is disabled. This could be because it
use the same account name as the administrator
account.
account is unavailable:
The authentication password is not set up.
User account is disabled. This could be because
the authentication password is not set, and only
the encryption account is set.
account is unavailable:
encryption is impossible.
Encryption is not possible and account is
disabled. This could be because:
•
Security option is not installed.
• Encryption password has not been specified.
add_sess_IPv4: bad trap addr: <IPv4 address>,
community: <community name>
The IPv4 address (0.0.0.0.) is unavailable when
the community access type is TRAP. Specify the
host IPv4 address for the TRAP destination.
add_sess_IPv6: bad trap addr: <IPv6 address>,
community: <community name>
The IPv6 address [::] is unavailable when the
community access type is TRAP. Specify the host
IPv6 address for the TRAP destination.
add_sess_IPv4: community <community name>
already defined.
The same community name already exists. Use
another community name.
Message List
209
To Next Page
Loading...
