• If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP
address is the valid address.
Configuration
msh> wins "interface_name" {on|off}
• {on} means "active" and {off} means "inactive".
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
Address configuration
Use the following command to configure a WINS server IP address:
msh> wins "interface_name" {primary|secondary} "IPv4 address"
• Use the "primary" command to configure the primary WINS server IP address.
• Use the "secondary" command to configure the secondary WINS server IP address.
• Do not use "255.255.255.255" as the IP address.
NBT (NetBIOS over TCP/IP) scope ID selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "ScopeID"
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface name Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
wsmfp
Use the "wsmfp" command to view and configure the WSD (Device), WSD (Printer) and WSD (Scanner)
settings.
Remote Maintenance Using telnet
191
To Next Page
Loading...
