• When staples have run out and [Auto Continue] is off, an error message will be displayed. Cancel
the staple function in the error message to continue printing.
•
If Staple or Shift Collate is selected with an optional finisher installed, the paper will be output to
the finisher shift tray irrespective of the setting.
• When printing on letterhead, stapling may not be at the specified position.
• If you cannot make staple settings even with a finisher installed, options may not be set correctly in
the printer driver. To correct the printer driver's option settings, see "Making Option Settings for the
Printer".
• When the finisher is being used for another function's job (for example, a copy job), printing will
start after that job ends.
• Be sure to set paper size and orientation in the printer driver when stapling.
• When duplex printing is selected, adjust staple positions to the binding orientation.
• Depending on the application you are using, print settings may not be stored and the printed result
may not be as expected.
• When you enable the staple function in the printer driver settings, make sure the [Ignore
Application Collate] check box is selected on the [Finishing] menu in the printer driver. If this check
box is not selected, more sets than intended might be printed.
• When printing restarts after removing jammed paper, the printing position may be different,
depending on the location of the jam.
• If the paper jam occurred in an optional finisher, printing will restart from the top page of the
data currently being printed, or from the page where the paper jam occurred.
• If the paper jam occurred in the machine, printing will restart from the page where the paper
jam occurred.
• Even if the paper jam occurred in the machine, the error will not be cleared unless the cover of
the finisher is opened and closed.
• For details about the optional finisher, see "Appendix", About This Machine.
• To remove paper misfeeds, see "Clearing Misfeeds" Troubleshooting.
• p.45 "Making Option Settings for the Printer"
Punch
With an optional finisher and punch unit attached, holes can be punched into printed outputs.
• Make option settings for the machine using the printer driver when bidirectional communication is
disabled.
2. Printing Documents
82
To Next Page
Loading...
