5. Select the standard message to be stamped, and then press [OK].
The selected standard message is shown above the highlighted [Standard Message].
6. Press [OK] twice.
7. Specify the destination, and then press the [Start] key.
The machine cannot stamp multiple standard messages.
• To print a standard message that is not programmed as a default, program it in advance in
“Program / Change / Delete Standard Message” in the Facsimile Features menu. For details
about the programming method, see “Send Settings”.
•
You can program one of the Quick Operation keys with operations for this function. Using the
Quick Operation Key allows you to omit steps 2, 3, and 6. For details about Quick Operation Key,
see “General Settings”.
• p.349 "General Settings"
•
p.353 "Send Settings"
Auto Reduce
When this function is turned on, if the receiver's paper is smaller than the size of the original you are
sending, the document is automatically reduced to fit onto the paper available at the other end.
2. Other Transmission Features
190
To Next Page
Loading...
