Configuring the WINS Server
This section explains configuring the WINS server.
The printer can be configured to register its NetBIOS name with a WINS server when the power is
turned on. This enables the NetBIOS name of the printer to be specified from SmartDeviceMonitor for
Admin even in a DHCP environment.
• WINS servers are supported by Windows Server 2003 or later.
•
For details about the WINS server settings, see Windows Help.
• If there is no reply from the WINS server, the NetBIOS name is registered by broadcast.
• The NetBIOS name can be entered using up to 15 alphanumeric characters.
Using Web Image Monitor
1. Start a Web browser.
2. Enter "http://(machine's IP address or host name) /" in the address bar to access the
printer whose settings you want to change.
Top Page of Web Image Monitor appears.
3. Click [Login].
The dialog box for entering the user name and password appears.
4. Enter the user name and password, and then click [Login].
Contact your administrator for information about the settings.
Depending on the configuration of your Web browser, the login user name and password might be
saved. If you do not want to save them, configure your Web browser's settings so that this
information is not saved.
5. In the menu area, click [Configuration].
6. Under "Network", click [IPv4].
7. Check that [Active] is selected for [WINS] in the [Ethernet + Wireless LAN] column, and
then enter the WINS server IPv4 address in [Primary WINS Server] and [Secondary
WINS Server].
8. Click [OK].
9. "Updating..." appears. Wait for about one or two minutes, and then click [OK].
10. Quit Web Image Monitor.
• p.131 "Using Web Image Monitor"
7. Appendix
306
To Next Page
Loading...
