• For information about these settings, see SmartDeviceMonitor for Client Help.
Windows 7, Windows Server 2008 R2:
1. Open the [Devices and Printers] window from the [Start] menu.
The [Devices and Printers] window appears.
2. Right-click the icon of the printer you want to use, and then click [Printer properties].
The printer properties appear.
3. Click the [Ports] tab, and then click [Configure Port].
The [Port Configuration] dialog box appears.
•
User, proxy, and timeout settings can be configured for IPP.
• For information about these settings, see SmartDeviceMonitor for Client Help.
How to enable Recovery/Parallel Printing
If no settings on the [Recovery/Parallel Printing] tab are available, follow the procedure below.
1. Start SmartDeviceMonitor for Client, and then right-click the SmartDeviceMonitor for
Client icon on the taskbar.
2. Point to [Property], click [Extended Features Settings], and then select the [Set Recovery/
Parallel Printing for each port] check box.
3. Click [OK] to close the [Extended Features Settings] dialog box.
1. Windows Configuration
28
To Next Page
Loading...
