msh> set rhpp6
msh> set lltd
Configuration
• Enter "up" to enable the protocol, and enter "down" to disable the protocol.
You can set the protocol to "active" or "inactive".
msh> set ipv4 {up|down}
• If you disable IPv4, you cannot use remote access after logging out. If you did this by mistake,
you can use the control panel to enable remote access via IPv4.
• Disabling IPv4 also disables lpr, ftp, rsh, diprint, web, snmp, ssl, ipp, http, bonjour, wsdev,
and sftp.
msh> set ipv6 {up|down}
• If you disable IPv6, you cannot use remote access after logging out. If you did this by mistake,
you can use the control panel to enable remote access via IPv6.
• Disabling IPv6 also disables lpr6, ftp6, rsh6, diprint6, ssl6, ipp6, http6, bonjour6, wsdev6,
and sftp6.
msh> set ipsec {up|down}
msh> set netware {up|down}
• This command is available only when the NetWare is installed.
msh> set smb {up|down}
msh> set lpr {up|down}
msh> set lpr6 {up|down}
msh> set ftp {up|down}
msh> set ftp6 {up|down}
msh> set rsh {up|down}
msh> set rsh6 {up|down}
msh> set diprint {up|down}
msh> set diprint6 {up|down}
msh> set web {up|down}
msh> set snmp {up|down}
msh> set ssl {up|down}
msh> set ssl6 {up|down}
• If Secured Sockets Layer (SSL, an encryption protocol) function is not available for the printer,
you cannot use the function by enabling it.
msh> set nrs {up|down}
Remote Maintenance Using telnet
175
To Next Page
