• WSD protocol (default setting: [Active])
Click [Configuration], click [IPv4] under [Network], and then enable [WSD (Scanner)].
•
[Display WSD Destination List] (default setting: [Do not Display])
Click [Configuration], click [Initial Settings] under [Scanner], and then set [Display WSD
Destination List] to [Display].
• Settings to enable WSD (Pull Type)
• WSD protocol (default setting: [Active])
Click [Configuration], click [IPv4] under [Network], and then enable [WSD (Scanner)].
• [Prohibit WSD Scan Command] (default setting: [Prohibit])
Click [Configuration], click [Initial Settings] under [Scanner], and then set [Prohibit WSD Scan
Command] to [Do not Prohibit].
Use the following procedure to enable both WSD (Push Type) and WSD (Pull Type).
1. On the [Start] menu, click [Network].
2. Double-click the icon for this machine.
3. Click [Login].
The Web Image Monitor login page appears.
4. Enter your login user name and password in the [Login User Name] and [Login
Password] boxes respectively, and then click [Login].
Consult your administrator if you require a login user name and password.
5. On the menu in the left frame, click [Configuration].
6. Under [Scanner], click [Initial Settings].
The [Initial Settings] page appears.
7. Set [Display WSD Destination List] to [Display].
8. Set [Prohibit WSD Scan Command] to [Do not Prohibit].
9. Click [OK].
• For details about displaying Web Image Monitor, see "Monitoring and Configuring the Machine",
Network and System Settings Reference. For details about using Web Image Monitor, see Web
Image Monitor Help.
Registering the machine to a client computer
Use the following procedure to register this machine to a client computer.
• You must log in as an Administrators group member to register the machine.
Before Sending Scan Files Using WSD
91
To Next Page
Loading...
