7. Specify the destination.
For details, see "Specifying the Destination Client Computer".
8. Press the [Start] key.
• If you are using this machine as a WSD scanner, you can specify only one destination per scan
job.
•
You cannot preview scanned images. After pressing the [Start] key, you can view the scanned
images on your computer.
• After you press the [Start] key, the client computer might time out and display the error message
"Automatic Scanning could not be completed". The cause of this message is likely to be one of the
following:
• Scan processing is taking a long time.
The machine will send the scan files again; please wait. Depending on the client computer’s
settings, you might have to perform a procedure on the client computer directly.
• The operating system might not support WSD (Push Type) features.
If the message appears every time you scan an original, it is possible that WSD (Push Type)
features cannot be used. Use WSD (Pull Type) for scanning.
• To check the files have been sent successfully, use the machine's Scanned Files Status screen or a
client computer. For details, see "Scanned Files Status".
• To cancel a specified destination, press the destination again, or press the [Clear/Stop] key.
• To cancel scanning, press the [Clear/Stop] key. You cannot cancel scanning from a client
computer.
• You cannot store files scanned using WSD on the machine.
• You cannot use WSD to send files stored on the machine.
• You cannot scan originals while other originals are being scanned.
• Two-sided originals are scanned for sideways opening (top-to-top orientation).
• If scanning does not begin after you press the [Start] key, the machine might not be registered to
the computer or the profile might be incorrectly configured. For details, see "Registering the
machine to a client computer" or "Creating a New Scan Profile".
• After scan files are sent, their destination settings are automatically cleared. If you want to preserve
this information, contact your local dealer for details.
• p.96 "Switching to the WSD Scanner Screen"
•
p.103 "Changing a Scan Profile"
• p.172 "Adjusting Image Density"
• p.173 "Setting of Original Feed Type"
Using the WSD Scanner (Push Type)
95
To Next Page
Loading...
