10. If necessary, press [Send File Type / Name] to specify settings such as file format and file
name.
For details, see "Specifying the File Type and File Name".
11. Press the [Start] key.
When scanning batches, place subsequent originals after the scan files have been sent.
When writing is complete, a confirmation message appears.
12. Press [Exit].
13. Remove the memory device from the media slot.
Remove the media from the media slot only after data has been written completely. Removing the
media while data is being written will result in corrupted data.
• Depending on the security settings, [Store to Memory Device] may not be displayed. Consult your
administrator.
•
You cannot specify where the data is saved. Files are saved in the root directory of the removable
memory device.
• If the removable memory device is partitioned, files are saved on the first partition.
• You cannot configure file information such as [User Name], [File Name], and [Password].
• The amount of free space on the memory device is displayed. Note that if the amount of free space
exceeds 10 GB, "9999.99 MB" will be displayed.
• To cancel writing, press the [Clear/Stop] key. If files are being written when writing is cancelled,
any partially written files are deleted. Only complete files are stored on the removable memory
device.
• The following table explains the activity of the media slot lamp.
Media Type Lamp Activity
USB Memory Lights up and remains lit as long as a USB flash memory is inserted.
SD Card Lights up only when the SD card is being accessed.
• p.163 "Various Scan Settings"
•
p.172 "Adjusting Image Density"
• p.173 "Setting of Original Feed Type"
• p.184 "Specifying the File Type and File Name"
5. Saving Scan Files on a Removable Memory Device
132
To Next Page
Loading...
