• Depending on the ambient temperature and humidity, steam may come from the exhaust vent
behind the control panel during printing. This is water vapor from the paper, not a sign of
malfunction.
•
If condensation forms inside the machine as a result of temperature change, the machine may not
print properly. To minimize this problem, use the optional anti-condensation heaters.
• The optional anti-humidity heater and optional anti-condensation heater warm the machine's
interior to prevent it becoming too humid. These heaters keep the machine warm even if it is
switched off.
• Be sure to make a note of the registered machine settings in case they are lost due to accident or
malfunction.
• The manufacturer shall not be liable for any loss or damage resulting from a failure of the machine,
loss of settings, or use of the machine.
Ventilation
When you use this machine in a confined space without good ventilation for a long time or print
large quantities, you might detect an odd smell.
This might cause the output paper to also have an odd smell.
When you detect an odd smell, regularly ventilate in order to keep the workplace comfortable.
• Set up the machine so that it does not directly ventilate towards people.
• Ventilation should be more than 30 m
3
/hr/person.
New machine smell
When a machine is new, it might have a unique smell. This smell will subside in about one week.
When you detect an odd smell, sufficiently ventilate and circulate the air in the room.
• p.49 "Turning On/Off the Power"
7. Remarks
108
To Next Page
Loading...
