[LAN Type] is displayed when wireless LAN board is installed. If Ethernet and Wireless LAN are
both connected, the selected interface has priority.
Ping Command
Check the network connection with ping command using the given IPv4 address.
If you fail to connect to the network, check the following, and then retry the ping command.
•
Make sure that "IPv4" in [Effective Protocol] is set to [Active].
• Check that the machine with assigned IPv4 address is connected to the network.
• There is a possibility that the same IPv4 address is used for the specified equipment.
Permit SNMPv3 Communication
Set the encrypted communication of SNMPv3.
Default: [Encryption / Cleartext]
If you select [Encryption Only], you need to specify the encryption password for the machine.
Permit SSL / TLS Communication
Set the encrypted communication of SSL/TLS.
Default: [Ciphertext Priority]
If you select [Ciphertext Only], you need to install the SSL certificate for the machine.
Host Name
Specify the host name.
Enter the host name using up to 63 characters.
You cannot enter a host name starting or ending with a hyphen.
You cannot enter a host name starting with "RNP" or "rnp".
Machine Name
Specify the machine name.
Enter the machine name using up to 31 characters.
IEEE 802.1X Authentication for Ethernet
Specify the IEEE 802.1X authentication for Ethernet.
Default: [Inactive]
For details about IEEE 802.1X authentication, see "Configuring IEEE 802.1X".
Restore IEEE 802.1X Authentication to Defaults
You can reset the IEEE 802.1X authentication settings to their defaults.
For details about IEEE 802.1X authentication, see "Configuring IEEE 802.1X".
• For details on how to access System Settings, see "Accessing User Tools".
Interface Settings
37
To Next Page
Loading...
