• The computer name can be entered using up to 63 alphanumeric characters.
•
If you do not specify a character string, the current setting is displayed.
Bonjour Installation location information setting
You can enter information about the location where the printer is installed.
msh> bonjour location "location"
• Information about the location can be entered using up to 32 alphanumeric characters.
• If you do not specify a character string, current setting is displayed.
Setting order of priority for each protocol
• msh> bonjour diprint [0-99]
• msh> bonjour lpr [0-99]
• msh> bonjour ipp [0-99]
You can specify the order of priority for "diprint", "lpr", and "ipp". Smaller numbers indicate higher
priority.
IP TTL setting
msh> bonjour ipttl [1-255]
You can specify the IP TTL (the number of routers a packet can pass through).
• The default is 255.
Resetting the computer name and location information
You can reset the computer name and location information.
msh> bonjour clear {cname|location}
• cname: Reset the computer name. The default computer name will be displayed when the
computer is restarted.
• location: Reset the location information. The previous location information will be deleted.
Interface configuration
msh> bonjour linklocal "interface_name"
• If you do not specify an interface, the Ethernet interface is selected automatically.
• If many types of interface are installed, configure the interface that communicates with
linklocal address.
• If you do not specify an interface, the Ethernet interface is automatically selected.
• wlan can be specified only when the IEEE 802.11 interface is installed.
Interface Interface configured
ether Ethernet interface
wlan IEEE 802.11 interface
Remote Maintenance Using telnet
157
To Next Page
Loading...
