Fax header
You can select to print a fax header on fax messages the other party receives.
The default is "1st Name".
Label insertion
Use label insertion to print information such as the destination name on the sheet printed out at the
destination.
Data is printed as follows:
•
Destination Name
The destination name specified in [Fax Destination] is printed with "To" before it at the top of
the sheet.
• Standard Message
A registered two-line sentence is printed under "Destination Name".
To use this function, set Label Insertion to [On] when programming fax destinations and also
press [Label Insertion] when sending fax documents.
Fax header and label insertion are also printed when sending by e-mail using the fax function.
You can program a standard message other than those registered in the machine.
See " Send Settings ", Facsimile Reference.
You can program the following items in an IP-Fax Destination:
IP-Fax
Register the IP-Fax destination. You can register the name using up to 128 characters. You must
make this setting when using IP-Fax.
This setting only works if the IP-Fax function has been selected.
SUB Code
Registering a SUB Code allows you to use Confidential Transmission to send messages to the other
fax machines which support a similar function called "SUB Code". See "Setting SUB Codes for
Transmission", Facsimile Reference.
SEP Code
Registering a SEP Code allows you to use Polling Reception to receive faxes from the other fax
machines which support Polling Reception. See "Setting SEP Codes for Reception", Facsimile
Reference.
Select Protocol
Select the protocol for the IP-Fax transmission.
This setting only works if the IP-Fax function has been selected.
• p.278 "Registering Names to a Group"
5. Registering Addresses and Users for Facsimile/Scanner Functions
242
To Next Page
Loading...
