Lockout setting items
The lockout function settings can be made using Web Image Monitor.
Setting Item Description Setting Values Default Setting
Lockout
Specify whether or
not to enable the
lockout function.
• Active
•
Inactive
• Inactive
Number of Attempts
before Lockout
Specify the number of
authentication
attempts to allow
before applying
lockout.
1-10 5
Lockout Release Timer
Specify whether or
not to cancel lockout
after a specified
period elapses.
• Active
•
Inactive
• Inactive
Lock Out User for
Specify the number of
minutes after which
lockout is canceled.
1-9999 min. 60 min.
Lockout release privileges
Administrators with unlocking privileges are as follows.
Locked out User Unlocking administrator
general user user administrator
user administrator, network administrator,
file administrator, machine administrator
supervisor
supervisor machine administrator
Specifying the User Lockout Function
This can be specified by the machine administrator using Web Image Monitor.
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
3. Configuring User Authentication
90
To Next Page
Loading...
