7. Enter the contents of the intermediate certificate.
In the certificate box, enter the contents of the intermediate certificate issued by the certificate
authority. For details about the items and settings of a certificate, see Web Image Monitor Help.
8. Click [OK].
9. Wait a moment for the device to restart, and then click [OK].
The intermediate certificate will be installed on the device. The "Certificate Details" screen will
inform you whether or not the installation of the intermediate certificate was successful. For details
about the "Certificate Details" screen, see Web Image Monitor Help.
Enabling SSL/TLS
After installing the device certificate in the machine, enable the SSL/TLS setting.
This procedure is used for a self-signed certificate or a certificate issued by a certificate authority.
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
3. Click [Login].
The network administrator can log in.
Enter the login user name and login password.
4. Click [Configuration], and then click [SSL/TLS] under "Security".
The SSL/TLS page appears.
5. Click [Active] for the protocol version used in "SSL/TLS".
6. Select the encryption communication mode for "Permit SSL/TLS Communication".
7. If you want to disable a protocol, click [Inactive] next to "SSL2.0", "SSL3.0", or "TLS".
Note that if you have selected [Active] in step 5, at least one of these protocols must be enabled.
8. Under "Encryption Strength Setting", specify the strength of encryption to be applied for
"AES", "3DES", "DES", "RC4", and/or "RC2". You must select at least one check box.
Note that the availability of encryption strengths will vary depending on the settings you have
specified for "SSL2.0", "SSL3.0", and "TLS".
9. Click [OK].
The SSL/TLS setting is enabled.
10. Click [OK].
11. Click [Logout].
7. Enhanced Network Security
224
To Next Page
Loading...
