Error Code Cause Solution
W0400-105
1. The UserPrincipleName
(user@domainname.xxx.com)
form is being used for the
login user name.
The user group cannot be
obtained if the
UserPrincipleName
(user@domainname.xxx.com)
form is used.
Use
"sAMAccountName(user)" to
log in, because this account
allows you to obtain the user
group.
W0400-105
2. Current settings do not
allow group retrieval.
Make sure the user group's
group scope is set to "Global
Group" and the group type is
set to "Security" in group
properties.
Make sure the account has
been added to user group.
Make sure the user group
name registered on the
machine and the group name
on the DC (domain controller)
are exactly the same. The DC
is case sensitive.
Make sure that "Use Auth. Info
at Login" has been specified in
"Auth. Info" in the user account
registered on the machine.
If there is more than one DC,
make sure that a confidential
relationship has been
configured between each DC.
W0400-106
The domain name cannot be
resolved.
Make sure that DNS/WINS is
specified in the domain name
in "Interface Settings".
W0400-200
Due to the high number of
authentication attempts, all
resources are busy.
Wait a few minutes and then
try again.
If Authentication Fails
287
To Next Page
Loading...
