When an Indicator to the Right of a Function
Key Is Lit
When an indicator to the right of a function key lights up, press the corresponding function key. Then,
follow the instructions displayed on the control panel.
If an error occurs in the function you are using, check the message that appears on the control panel,
see "Messages Displayed" for the relevant function.
The following table explains problems that cause the indicator to light.
Problem Causes Solutions
Documents and reports do
not print out.
The paper output tray is full. Remove the prints from the tray.
Documents and reports do
not print out.
There is no paper left. Load paper. See "Loading Paper",
About This Machine.
An error has occurred. The function whose indicator
is lit is defective.
Check the displayed message, and
then take an appropriate action. See
"Messages Displayed" of each
chapter.
You can use other functions normally.
When an Indicator to the Right of a Function Key Is Lit
15
To Next Page
Loading...
