5. Click [Next >].
6. Click [Local printer attached to this computer], and then click [Next >].
7. Click [Create a new port:].
8. Click [SmartDeviceMonitor] in [Type of port:], and then click [Next >].
9. Click [IPP].
10. In the [Printer URL] box, enter "http://(machine's IP address or host name)/printer" as
the machine's address.
If the server authentication is issued, to enable SSL (a protocol for encrypted communication), enter
"https://(machine's IP address or host name)/printer" (Internet Explorer 5.01, or a higher version
must be installed).
(example IP address: 192.168.15.16)
http://192.168.15.16/printer
https://192.168.15.16/printer
You can enter "http://machine's IP address or host name/ipp" as the machine's address.
If the address is "192.168.001.010", you must enter it as "192.168.1.10" to connect to the
machine.
11. Enter a name for identifying the machine in [IPP Port Name]. Use a name different from
the one of any existing port.
If a name is not specified here, the address entered in the [Printer URL] box becomes the IPP port
name.
12. Click [Detailed Settings] to make necessary settings, and then click [OK].
For information about the settings, see SmartDeviceMonitor for Client Help.
13. Click [OK].
14. Check that the name of the printer driver you want to install is selected, and then click
[OK].
15. Change the name of the machine if you want, and then click [Next >].
Select [Yes] to configure the machine as default.
16. Specify whether or not to share the machine, and then click [Next >].
17. Specify whether or not to print a test page, and then click [Next >].
18. Click [Finish].
If the [Hardware Installation] message appears, click [Continue Anyway].
The printer driver installation starts.
• To stop installation of the selected driver, click [Cancel] before installation is complete.
Using the SmartDeviceMonitor for Client Port
23
To Next Page
Loading...
