• During Immediate Transmission or when in User Tools mode, the machine cannot scan an original.
Broadcasting sequence
Use the broadcasting function to send the same original to multiple destinations simultaneously.
You can broadcast via multiple transmission types (fax, IP-Fax, Internet Fax, e-mail, and folder) at the
same time.
To specify multiple destinations, specify the first destination, and then specify the next destination by
pressing [Add].
If you dial several destinations for the same document (broadcasting), the documents are sent in the
order in which they were dialed. If the fax document could not be transmitted, the machine redials that
destination after the last destination specified for broadcasting. For example, if you specify four
destinations, A through D, for broadcasting, and if the lines to destinations A and C are busy, the
machine dials the destinations in the following order: A, B, C, D, A, and C.
To check the transmission progress, print the TX file list. See “Printing a List of Files in Memory (Print TX
File List)”.
If the optional extra G3 interface unit is installed, you can use the Simultaneous Broadcast function to
send faxes simultaneously on different phone lines. See “Simultaneous Broadcast Using Multiple Line
Ports”.
If you specify a second transmission while broadcasting to several destinations, faxes are transmitted
alternately to each remaining destination in the current and second broadcast.
For example, if you specify a broadcast to destinations A and B, and then specify a broadcast to
destinations C and D while transmission to destination A is in progress, the machine sends the faxes in
the following order: A, C, B, and then D.
If the previous file and next file are both on standby, these are also sent in the same order.
• To avoid accidentally specifying multiple destinations, you can disable broadcasting. You cannot
specify group destinations if you disable broadcasting. You can specify only one address at a time.
For details about how to disable broadcasting, contact your service representative.
•
The Facsimile Features menu includes a user parameter setting (switch 17, bit 2) that enables you
to configure the machine to force the user to press [Add] whenever s/he specifies a destination
using a destination key. This prevents users accidentally sending documents to the wrong
destination. See “Parameter Settings”.
• p.86 "Simultaneous Broadcast Using Multiple Line Ports"
•
p.254 "Printing a List of Files in Memory (Print TX File List)"
Transmission Modes
31
To Next Page
Loading...
