• You must set the Personal Box and register a delivery destination beforehand. Personal Boxes can
be programmed in “Box Setting” in the Facsimile Features menu. For details about the
programming method, see “Box Settings”.
•
This function is not available when you set received documents to be delivered to the network
delivery server. Use the Fax RX File Transmission in System Settings to configure delivery of
received documents. For details about Fax RX File Transmission, see “File Transfer”, Network and
System Settings Reference.
• If the destination specified is an e-mail address, the received document is routed to that destination
as e-mail.
•
You cannot specify a group as the receiver.
• You can route documents received from any fax machine, regardless of manufacturer.
• p.413 "Box Settings"
Routing received documents to specified lines when optional extra G3 line is
equipped
This machine can route received documents to specified lines when optional extra G3 line is equipped.
When optional G3 line is equipped, you can route received documents separately for each line. You
need to register a SUB code for each line prior to using this function.
Register “1” for G3-1, “2” for G3-2 and “3” for G3-3.
You need to register Fax destinations, IP-Fax destinations, Internet Fax destinations, e-mail destinations,
and folder destinations as transmission destinations of the Personal Box or end receiver of the Transfer
Box. This function can only be used when all settings have been completed.
• The optional extra G3 interface unit is required to use this function.
•
You must set the Personal or Transfer Box and register a transmission destination or end receiver
beforehand.
• This function is not available when you set received documents to be delivered to the network
delivery server.
• This function is not available if the Information Box is set.
3. Reception
216
To Next Page
Loading...
