RM0444 Rev 5 425/1390
RM0444 Digital-to-analog converter (DAC)
441
Bits 27:24 MAMP2[3:0]: DAC channel2 mask/amplitude selector
These bits are written by software to select mask in wave generation mode or amplitude in
triangle generation mode.
0000: Unmask bit0 of LFSR/ triangle amplitude equal to 1
0001: Unmask bits[1:0] of LFSR/ triangle amplitude equal to 3
0010: Unmask bits[2:0] of LFSR/ triangle amplitude equal to 7
0011: Unmask bits[3:0] of LFSR/ triangle amplitude equal to 15
0100: Unmask bits[4:0] of LFSR/ triangle amplitude equal to 31
0101: Unmask bits[5:0] of LFSR/ triangle amplitude equal to 63
0110: Unmask bits[6:0] of LFSR/ triangle amplitude equal to 127
0111: Unmask bits[7:0] of LFSR/ triangle amplitude equal to 255
1000: Unmask bits[8:0] of LFSR/ triangle amplitude equal to 511
1001: Unmask bits[9:0] of LFSR/ triangle amplitude equal to 1023
1010: Unmask bits[10:0] of LFSR/ triangle amplitude equal to 2047
≥ 1011: Unmask bits[11:0] of LFSR/ triangle amplitude equal to 4095
Note: These bits are available only on dual-channel DACs. Refer to Section 16.3: DAC
implementation.
Bits 23:22 WAVE2[1:0]: DAC channel2 noise/triangle wave generation enable
These bits are set/reset by software.
00: wave generation disabled
01: Noise wave generation enabled
1x: Triangle wave generation enabled
Note: Only used if bit TEN2 = 1 (DAC channel2 trigger enabled)
These bits are available only on dual-channel DACs. Refer to Section 16.3: DAC
implementation.
Bits 21:18 TSEL2[3:0]: DAC channel2 trigger selection
These bits select the external event used to trigger DAC channel2
0000: SWTRIG2
0001: dac_ch2_trg1
0010: dac_ch2_trg2
...
1111: dac_ch2_trg15
Refer to the trigger selection tables in Section 16.4.2: DAC pins and internal signals for
details on trigger configuration and mapping.
Note: Only used if bit TEN2 = 1 (DAC channel2 trigger enabled).
These bits are available only on dual-channel DACs. Refer to Section 16.3: DAC
implementation.
Bit 17 TEN2: DAC channel2 trigger enable
This bit is set and cleared by software to enable/disable DAC channel2 trigger
0: DAC channel2 trigger disabled and data written into the DAC_DHR2 register are
transferred one dac_pclk clock cycle later to the DAC_DOR2 register
1: DAC channel2 trigger enabled and data from the DAC_DHR2 register are transferred
three dac_pclk clock cycles later to the DAC_DOR2 register
Note: When software trigger is selected, the transfer from the DAC_DHR2 register to the
DAC_DOR2 register takes only one dac_pclk clock cycle.
These bits are available only on dual-channel DACs. Refer to Section 16.3: DAC
implementation.
To Next Page
Loading...
Need help?
General
