• The [Mixed Original Sizes] function is available only if the ADF is installed on the machine. Note
that in some countries, the ADF is an optional component and must be purchased separately.
•
Selecting both [Mixed Original Sizes] and [Erase Border] reduces the scanning speed.
• You can enter 140 mm (5.5 inches) or higher in Original Size (X1 and Y1) under [Custom Size].
• If the size of an original placed in the ADF cannot be detected automatically, the original might be
scanned at a different size. For details about paper sizes that can be automatically detected when
placed in the ADF, see "Specifications".
• p.222 "Specifications"
Relationship of original of mixed sizes and scan size
Scanning methods for originals mixed with different sizes (such as A3 & A4 or B4 & B5) differ
depending on the settings you make for the scan size and whether you use the exposure glass or the
ADF.
•
If you select [Mixed Original Sizes], the machine detects the length of each original and scans
them.
• If a template size is selected, the machine scans originals at the selected size regardless of the
actual size of originals. If an original is smaller than the selected size, the machine applies margins
to the scan area.
• If [Auto Detect] is selected for scanning originals from the exposure glass, the machine detects the
size of individual originals and scans accordingly.
• If only [Auto Detect] is selected for scanning the original with ADF, the machine scans all originals
in the size of the largest original among them.
• When scanning originals of different length at the same time, place them correctly by referring to
the chart below. The paper guides cannot be adjusted to small size originals, which may cause
slightly tilted scanning.
8. Various Scan Settings
166
To Next Page
Loading...
