E-mail Communication Port
Specify the port numbers for receiving Internet faxes. The specified POP3 port number is used for
[POP before SMTP].
Default for "POP3": [110]
Default for "IMAP4": [143]
Enter a port number between 1 and 65535 using the number keys, and then press the [ ] key.
E-mail Reception Interval
Specify, in minutes, the time interval for receiving Internet faxes via POP3 or IMAP4 server.
Default: [On], [15 minute(s)]
If [On] is selected, the time can be set from 2 to 1440 minutes in increments of one minute.
Max. Reception E-mail Size
Specify the maximum reception e-mail size for receiving Internet faxes.
Default: [2 MB]
Enter a size from 1 - 50 MB in increments of one megabyte.
E-mail Storage in Server
Specify whether or not to store received Internet fax e-mails on the POP3 or IMAP4 server.
Default: [Off]
Default User Name / Password (Send)
Specify the user name and password required when sending scan files directly to a shared folder
on a computer running Windows, to an FTP server, or to a NetWare server.
Enter in up to 64 characters.
Program / Change / Delete E-mail Message
You can program, change, or delete the e-mail message used when sending an Internet fax or
scan file as an attachment.
•
Program/Change:
1. Press the [User Tools/Counter] key.
2. Press [System Settings].
3. Press [File Transfer].
4. Press [
Next].
5.
Press [Program / Change / Delete E-mail Message].
6. Check that [Program / Change] is selected.
7. Press [*Not Programmed].
To change the registered e-mail message, select the e-mail message to change.
8. Press [Change] under the "Name".
File Transfer
47
To Next Page
Loading...
