Message Problem and solutions
Current IP address (<current IP address>). The IP address <current IP address> was acquired
from the DHCP server.
Current IPX address <IPX address> The current IP address is <IPX address>.
DHCP lease time expired. The DHCP lease time has expired. Perform the
DHCP discover again. The IP address you have
been using is no longer available.
DHCP server not found. The DHCP server was not found. Make sure that
the DHCP is on the network.
DHCPv6 server not found. The DHCPv6 server was not found. Make sure
that the DHCPv6 is on the network.
disconnected The supplicant has no connection.
Duplicate IP=<IP address>(from <MAC
address>).
A conflicting IPv4 or IPv6 address was used. Each
IPv4 or IPv6 address must be unique. Check the
device address in [MAC address].
Established SPX Connection with PServer,
(RPSocket=<socket number>,
connID=<connection ID>)
Connection to the print server was established
when the remote printer went online.
exiting The LPD service has completed and the process is
exiting.
Exit pserver (In the print server mode) The print server function
is disabled because the necessary print server
settings have not been made.
Frametype=<frametype name> The specified frame type name <frame type
name> is for NetWare use.
httpd start. The httpd has started.
IEEE 802.11 Card does NOT support WPA. A wireless card that does not support WPA is
installed. Install a wireless card that supports
WPA.
IEEE 802.11 Card Firmware REV.<version> Displays the version number of the 802.11 card's
firmware.
4. Monitoring and Configuring the Machine
212
To Next Page
Loading...
