5. Specify IPv4 Address.
For details on how to specify the IPv4 address, see "Interface Settings", Network and System
Settings Reference.
6. Be sure to connect this machine to a network that only administrators can access.
7. Start Web Image Monitor, and then log in to the machine as the administrator.
For details about logging in to Web Image Monitor as an administrator, see "Using Web
Image Monitor to Configure Administrator Authentication".
8. On the Configuration screen, click [E-mail] under "Device Settings", and then specify
the administrator address in "Administrator E-mail Address".
9. Install the device certificate.
For information on how to install the device certificate, see "Protection Using Encryption".
The settings for device certificate creation can be configured only if an administrator e-mail
address is specified.
10. Enable secure sockets layer (SSL).
For details about enabling SSL, see "Enabling SSL/TLS".
11. Change the administrator's user name and password.
For details about specifying administrators' user names and passwords, see "Changing the
Administrator's User Name and Password".
To enable higher security, proceed to step 2 in the following "Enabling enhanced security".
12. Log out, and then quit Web Image Monitor.
13. Disconnect the machine from the administrators-only network, and then connect it to
the general use network.
Enabling enhanced security
1. Configure the security settings for the machine by following steps 1 to 11 in the
previous section, "Enabling security".
2. To use only the ports that have high security, set [Network Security Level] to [Level
2].
If [Network Security Level] is set to [Level 2], some functions will be unavailable.
For details, see "Specifying Network Security Level" and "Enabling and Disabling Protocols".
3. Set [FTP], which has weak security, to [Inactive] and also set [SNMPv3 Function] to
[Inactive].
For details about the functions that will be unavailable if "FTP" and "SNMPv3" are set to
[Inactive], see "Enabling and Disabling Protocols".
4. Click [OK].
5. Log out, and then quit Web Image Monitor.
Setting up the Machine
15
To Next Page
Loading...
