5. Press [Change] for "Unique Attribute".
6. Enter the unique attribute and then press [OK].
Specify Unique Attribute on the machine to match the user information in the LDAP server with that
in the machine. By doing this, if the Unique Attribute of a user registered in the LDAP server matches
that of a user registered in the machine, the two instances are treated as referring to the same user.
You can enter an attribute such as "serialNumber" or "uid". Additionally, you can enter "cn" or
"employeeNumber", provided it is unique. If you do not specify the Unique Attribute, an account
with the same user information but with a different login user name will be created in the machine.
7. Press [OK].
8. Press the [User Tools/Counter] key.
A confirmation message appears.
If you press [Yes], you will be automatically logged out.
• p.158 "Limiting Available Functions"
Selecting Simple (Limitation)
If you select [Simple (Limitation)], you can specify clients for which printer job authentication is not
required. Specify [Parallel Interface: Simple], [USB: Simple] and the clients' IPv4 address range in which
printer job authentication is not required. Specify this setting if you want to print using unauthenticated
printer drivers or without any printer driver. Authentication is required for printing with non-specified
devices.
If you select [Simple (Limitation)], you can print even with unauthenticated printer drivers or devices.
Specify this setting if you want to print with a printer driver or device that cannot be identified by the
machine or if you do not require authentication for printing. However, note that, because the machine
does not require authentication in this case, it may be used by unauthorized users.
3. Configuring User Authentication
72
To Next Page
Loading...
