• Should the main power switch be turned off before "Erase All Memory" is completed, overwriting
will continue once the main power switch is turned back on.
•
If an error occurs before overwriting is completed, turn off the main power. Turn it on again, and
then repeat from step 2.
• If you specify to both overwrite and encrypt the data, the data will all be encrypted.
• p.35 "Logging in Using Administrator Authentication"
•
p.36 "Logging out Using Administrator Authentication"
• p.143 "Methods of Overwriting"
Suspending Erase All Memory
The overwriting process can be suspended temporarily.
• Erase All Memory cannot be canceled.
1. Press [Suspend] while Erase All Memory is in progress.
2. Press [Yes].
Erase All Memory is suspended.
3. Turn off the main power.
Before turning the power off, see "Turning On the Power", About This Machine.
• To resume overwriting, turn on the main power.
Deleting Data on the Hard Disk
149
To Next Page
Loading...
