Error Code Cause Solution
W0104-000 Failed to encrypt password.
1. A password error occurred.
Make sure the password is
entered correctly.
2. "Restrict Use of Simple
Encryption" is enabled.
The administrator has
restricted use of simple
encryption. You can use the
encryption key if it has been
specified in the driver.
3. A driver encryption key
error occurred.
Make sure that the encryption
key is correctly specified on
the driver.
W0105-000
A login user name was not
specified but a DeskTopBinder
operation was performed.
Set the DeskTopBinder login
user name correctly.
W0206-002
The user attempted
authentication from an
application on the "System
Settings" screen, where only
the administrator has
authentication ability.
Only the administrator has
login privileges on this screen.
Log in as a general user from
the application's login screen.
W0206-003
An authentication error
occurred because the user
name contains a space, colon
(:), or quotation mark (").
Recreate the account if the
account name contains any of
these prohibited characters.
If the account name was
entered incorrectly, enter it
correctly and log in again.
W0207-001
An authentication error
occurred because the Address
Book is being used at another
location.
Wait a few minutes and then
try again.
9. Troubleshooting
282
To Next Page
Loading...
