Problem Causes Solutions
The same copy area is dirty
whenever making copies.
• The original that has
already been printed is
scanned.
•
Original Type is set to
[Text / Photo], and an
original with text and
photographs that can
hardly be distinguished
from each other is
loaded.
On the control panel, press
[Generation Copy], and then begin
copying.
Copies are too light. Image density is too light. Adjust the image density settings. See
"Adjusting Copy Image Density", Copy
and Document Server Reference
.
Copies are too light. A light copy may result when
you use damp or rough
grain paper.
• Use recommended paper. For
details about recommended
paper, see "Recommended Paper
Sizes and Types", About This
Machine.
•
Use paper that has been stored in
the recommended temperature
and humidity conditions. For
details about the proper way to
store paper, see "Paper Storage",
About This Machine.
Parts of images are not
copied.
The original is not set
correctly.
Set originals correctly. See "Placing
Originals", Copy and Document
Server Reference
.
Parts of images are not
copied.
The correct paper size is not
selected.
Select the proper paper size.
Parts of images are not
copied.
Even if you place originals
on the exposure glass, or
ADF correctly, margin of a
few millimeters on all four
sides of the original might
not be copied.
Use "Create Margin" function to
reduce the image of its original size.
For details about missing image area,
see "Create Margin", Copy and
Document Server Reference .
2. Troubleshooting When Using the Copy/Document Server Function
30
To Next Page
